Support

FAQs

Assembly and Connection Hitachi RAD

Connection

Aidoo Hitachi RAD Wi-Fi controller

The unit controller must remain working in parallel with your Aidoo.

Perform all of the connections with a total absence of power.

Follow these steps to connect them:

  1. Fix your Aidoo close to the AC unit to be controlled using the material supplied (double-sided adhesive tape or screws).

    Important: Check that you have a Wi-Fi signal available before fixing it.
    Assembly Aidoo

  2. Disconnect the indoor unit.
  3. Find the HLINK/CN7/CN1101 connector among the electronic components of the indoor unit and connect the Aidoo to this port using the supplied cable.
    Connection Aidoo HI2
  4. Power the indoor unit. Check the LED:
    green (blinking)
    red (solid)
1804
All FAQs